Value Collection WS-MH-FIBR-197 Twisted Nylon Rope

Product Description

The VALUE COLLECTION WS-MH-FIBR-197 is a twisted nylon rope rated for up to 709 pounds of load capacity with a maximum length of 200 feet and a 1/2-inch diameter. Constructed from nylon, it delivers resistance to abrasion, moisture, and repeated flexing, making it suitable for demanding job-site and facility applications. The twisted lay construction provides good grip and handling characteristics, and the rope coils and stores consistently without excessive kinking. This type of rope is commonly selected by contractors, maintenance crews, and trade professionals who need a reliable general-purpose cordage solution.

This rope is suited for a wide range of residential and commercial applications including rigging support lines, pull lines for conduit or cable runs, securing loads, and utility tie-down tasks. At 200 feet, a single coil covers extended runs without splicing. The 1/2-inch diameter fits standard rope fittings, cleats, and blocks commonly found on job sites. It is not rated or intended for life-safety fall-arrest use.

Key Features

• 200-foot maximum length in a single coil — no splicing needed for long runs
• 1/2-inch diameter fits standard rope hardware and fittings
• 709-pound load capacity for general utility and rigging support tasks
• Twisted nylon construction resists abrasion and moisture absorption
• Nylon material maintains flexibility across a range of ambient temperatures

Compatibility

Designed as a general-purpose twisted nylon rope suitable for use with standard rope cleats, blocks, hooks, and fittings that accept 1/2-inch diameter cordage in commercial and residential utility applications.

Installation Notes

Inspect the rope for fraying, cuts, or wear before each use. Always verify that the anchor points and hardware being used are rated to meet or exceed the rope load capacity. Cut ends should be heat-sealed or whipped to prevent unraveling. This rope is not certified for fall-arrest or life-safety applications and must not be used as a primary load-bearing element in overhead lifting without verification against applicable ASME or OSHA standards.