Value Collection WS-HF-CAM-024 Square O-ring Nbr 2in Id

Product Description

The VALUE COLLECTION WS-HF-CAM-024 is a square cross section O-ring manufactured from Nitrile Butadiene Rubber (Buna-N), a synthetic elastomer well suited for applications involving oils, fuels, and hydraulic fluids. The ring measures 2 inches inside diameter and 2.63 inches outside diameter, with a 0.315-inch square cross section. Unlike standard round-profile O-rings, the square cross section provides a larger sealing surface area, which can improve static seal performance in grooved fittings, valves, and port connections. This part is sold individually and carries a minimum order quantity of 5 units.

This O-ring is commonly used in plumbing, HVAC, and fluid-handling assemblies where a Buna-N-compatible static or low-motion dynamic seal is required. Typical install scenarios include valve bonnets, pump housings, threaded port plugs, and manifold connections exposed to petroleum-based lubricants or water. The square profile makes it a suitable choice for rectangular-groove seal seats where a round O-ring would not seat correctly. Plumbers, HVAC technicians, and industrial maintenance trades install this type of sealing component during routine valve and pump servicing.

Key Features

• Square cross section profile increases sealing contact area compared to standard round O-rings
• Nitrile Butadiene Rubber (Buna-N) material offers good resistance to petroleum oils, hydraulic fluids, and water
• 2 inches inside diameter and 2.63 inches outside diameter for precise groove fitment
• Dash Number 001 designation aids cross-referencing to industry-standard O-ring sizing charts
• Lightweight at 0.03 pounds for easy handling and bulk stocking

Compatibility

Designed as an OEM-style replacement or service seal for plumbing, HVAC, and fluid-system components requiring a square cross section Buna-N O-ring with a 2-inch inside diameter and Dash 001 designation.

Installation Notes

Installation should be performed by a qualified plumber or HVAC technician following applicable IPC or IFGC guidelines. Shut off fluid supply and relieve system pressure completely before removing any fitting or valve component that retains this seal. Inspect the groove for burrs or corrosion before seating the O-ring, and apply a compatible lubricant to ease installation and prevent tearing. Do not overstretch the ring during installation, as permanent deformation will compromise the seal.