Value Collection SMPPI0-600620-100BX Sheet Metal Screw

Product Description

The VALUE COLLECTION SMPPI0-600620-100BX is a No. 6 pan head sheet metal screw with a Phillips drive, designed for fast, secure fastening in light-gauge sheet metal and similar thin-material applications. The screw measures 5/8 inch in length under the head and features a Type AB point for self-starting in pre-punched or pre-drilled pilot holes. Constructed from Grade 2 steel with a zinc finish for corrosion resistance, this fastener suits standard trade and light industrial assembly work. Sold in a box of 100 units.

This fastener is commonly used by HVAC technicians, sheet metal workers, plumbers, and electricians for securing duct panels, junction box covers, equipment enclosures, and light sheet metal assemblies. The pan head profile provides a low-profile bearing surface that distributes clamping load across thin material without pulling through. The Phillips drive is compatible with standard No. 2 Phillips bits and power drivers. The Type AB thread and point combination bites into sheet metal without requiring a tap.

Key Features

• No. 6 thread size with Type AB self-starting point for use in sheet metal without tapping
• 5/8 inch length under head suits thin-gauge sheet metal and panel fastening
• Pan head profile keeps a low profile while distributing load evenly
• Phillips drive compatible with standard No. 2 bits and impact drivers
• Grade 2 steel construction with zinc finish for general corrosion resistance
• Box of 100 screws supports job-site and service van stocking

Compatibility

Designed as a general-purpose sheet metal fastener suitable for light-gauge metal panels, duct work covers, equipment enclosures, and similar thin-material assemblies where a No. 6 pan head Phillips sheet metal screw is specified.

Installation Notes

Sheet metal screws are typically installed by HVAC technicians, electricians, and sheet metal workers using a No. 2 Phillips bit with a power driver or hand screwdriver. Use a pilot hole or pre-punched opening sized to the thread recommendations for No. 6 Type AB screws to avoid material distortion. Do not overtighten, as pan head screws in thin-gauge metal can strip the material or deform the bearing surface. Follow applicable mechanical codes for fastener spacing and edge distance in duct and enclosure applications.