Value Collection SAEW0880025OZ Sae Flat Washer 7/8 in

Product Description

The VALUE COLLECTION SAEW0880025OZ is an SAE flat washer designed for use with 7/8-inch screws and fasteners. Made from steel with a zinc-plated finish, this washer distributes load across a fastening surface and helps protect against corrosion in standard service conditions. The 15/16-inch inner diameter fits snugly over a 7/8-inch fastener shank, and the 1-3/4-inch outer diameter provides a broad bearing surface. At 9/64-inch thick, it meets SAE dimensional standards for this screw size. Electricians, plumbers, HVAC technicians, and general contractors use SAE flat washers during equipment mounting, panel installation, pipe support bracketing, and structural assembly work.

This washer is suited for residential and light commercial applications where standard SAE fastener hardware is specified. It is used wherever a 7/8-inch bolt or screw requires a load-spreading or surface-protecting washer under the head or nut. Typical applications include mechanical equipment bases, support strut assemblies, and utility bracketing. The zinc plating provides a baseline level of corrosion resistance appropriate for indoor and sheltered outdoor installations. This listing covers a minimum order quantity of 25 pieces, packaged as a single unit.

Key Features

• SAE flat washer profile meets standard dimensional requirements for 7/8-inch screw size
• 15/16-inch inner diameter for proper fit over 7/8-inch fastener shanks
• 1-3/4-inch outer diameter for broad load distribution across mounting surfaces
• 9/64-inch thickness meets SAE thickness specification for this size
• Steel construction with zinc-plated finish for corrosion resistance in standard service conditions
• Sold in multiples of 25, suitable for production work or stocking a service van

Compatibility

Designed as a standard SAE flat washer for use with 7/8-inch bolts, screws, and threaded fasteners in mechanical, structural, and utility installations.

Installation Notes

SAE flat washers are installed by placing them over the fastener shank before seating the nut or bolt head against the work surface. Ensure the inner diameter seats flush with no binding on the fastener threads. In electrical or HVAC panel work, follow applicable NEC or equipment manufacturer torque and fastener specifications. Inspect zinc coating for damage before use in wet or corrosive environments, and substitute a more corrosion-resistant washer type if the service environment requires it.