Value Collection SAEW0440100OZ Sae Flat Washer 7/16 in

Product Description

The VALUE COLLECTION SAEW0440100OZ is a standard SAE flat washer designed for use with 7/16 inch fasteners. Stamped from steel and finished with a zinc plating for corrosion resistance, this washer distributes load across the bearing surface to protect the joined materials and prevent fastener pull-through. With an inside diameter of 15/32 inches, an outside diameter of 59/64 inches, and a thickness of 1/16 inch, it meets standard SAE dimensional specifications. Electricians, plumbers, HVAC technicians, and general tradespeople use flat washers like this in equipment mounting, panel attachment, and structural fastening applications.

This washer is suited for a wide range of residential and light commercial trade applications where a 7/16 inch screw or bolt is used. Common uses include securing equipment brackets, mounting plates, junction boxes, conduit supports, and mechanical assemblies. The SAE sizing standard makes it compatible with the broad range of imperial-measure fasteners found throughout HVAC, plumbing, and electrical installation work. Sold in multiples of 100, this product is practical for stocking in a service van or shop for routine fastening tasks.

Key Features

• SAE-standard flat washer sized for 7/16 inch screws and bolts
• Steel construction with zinc-plated finish for corrosion resistance
• Inside diameter of 15/32 inches fits standard 7/16 inch fastener shanks
• Outside diameter of 59/64 inches provides adequate load distribution
• Thickness of 1/16 inch for consistent bearing surface
• Minimum order quantity of 100 units — suitable for shop or van stock

Compatibility

Designed as a standard SAE-dimensioned flat washer for use with 7/16 inch imperial fasteners across general trade and mechanical fastening applications.

Installation Notes

Flat washers are installed by any trade performing bolted or screwed connections — including HVAC, plumbing, and electrical technicians. Place the washer between the fastener head or nut and the mating surface before tightening. Always de-energize electrical equipment and shut off fluid systems before performing any work on fastened assemblies. Follow applicable codes such as NEC or IPC for fastener and support requirements specific to each trade application.