Value Collection S04064630 Wheel Brush 6 in Crimped

Product Description

The VALUE COLLECTION S04064630 is a 6-inch diameter wheel brush designed for deburring, cleaning, and surface preparation on metal, weld seams, and fabricated parts. It uses crimped brass-coated steel wire with a filament diameter in the 0.010 to 0.019 inch range, which delivers consistent contact pressure and resists wire breakage during extended use. The brush mounts via a 1-1/4 inch arbor hole and is rated to 6,000 RPM. With a face width of 1 inch and a trim length of 1-1/8 inches, it suits bench grinders and arbor-mounted setups used in metalworking, maintenance, and fabrication shops. Weight is 2 pounds.

This wheel brush is used in industrial and trade settings for scale removal, rust cleaning, weld spatter removal, and general surface conditioning on ferrous and non-ferrous materials. It is a common tool for machinists, maintenance technicians, pipefitters, and fabricators working with benchtop grinders or dedicated arbor-mounted grinding stations. The crimped wire configuration is preferred when moderate aggression and surface blending are needed rather than aggressive material removal.

Key Features

• 6-inch outside diameter with 1-inch face width for broad contact coverage
• Crimped brass-coated steel wire for controlled aggression and corrosion resistance
• Filament wire diameter in the 0.010 to 0.019 inch range for consistent surface conditioning
• 1-1/4 inch arbor hole mount for standard bench grinder and arbor spindle compatibility
• Rated to 6,000 RPM maximum operating speed
• 1-1/8 inch trim length for extended service life between dressings

Compatibility

Designed for use with standard arbor-hole bench grinders and arbor-mounted spindles accepting a 1-1/4 inch bore. No shank is included; the arbor hole mount configuration is required.

Installation Notes

Installation should be performed by a qualified technician familiar with abrasive wheel mounting procedures. Always power down and lock out the grinder before mounting or removing the brush. Verify that the machine spindle speed does not exceed the 6,000 RPM maximum rating marked on the brush. Inspect the wire fill for damage before each use and do not operate with loose, broken, or severely worn filaments.