Value Collection S04064598 Wheel Brush 4 Inch Crimped

Product Description

The VALUE COLLECTION S04064598 is a 4-inch arbor-hole wheel brush designed for surface preparation, deburring, cleaning, and finishing work on metal and other hard materials. The brush uses crimped brass-coated steel wire filaments with a diameter in the 0.0100 to 0.0199 inch range, delivering consistent, controlled abrasive action across the work surface. Rated to 8,000 RPM, it mounts via a 3/4-inch arbor hole and fits standard bench grinders and angle grinder arbors. The 11/16-inch trim length provides good filament flex for contour work. Machinists, fabricators, and maintenance technicians are the typical users for this type of brush.

This wheel brush is suited for both shop and field use on tasks such as weld spatter removal, rust and scale cleaning, paint stripping, and general surface conditioning. The crimped wire configuration reduces wire breakage under moderate pressure and distributes abrasive contact evenly across irregular surfaces. The brass-coated steel fill material is appropriate for ferrous and non-ferrous metals where mild abrasion is needed without heavy material removal. This brush is a single-piece unit with no shank included, requiring a separate arbor or mandrel for mounting.

Key Features

• 4-inch outside diameter for broad surface coverage on bench or angle grinder setups
• Crimped wire fill reduces wire fatigue and breakage during use
• Brass-coated steel filaments with 0.0100 to 0.0199 inch wire diameter for controlled abrasion
• 8,000 RPM maximum speed rating for compatibility with standard bench grinders
• 3/4-inch arbor hole (30.00 mm inside diameter) fits common grinder spindles
• 11/16-inch trim length allows filament flex for contour and edge work

Compatibility

Designed for use with bench grinders and power tools equipped with a 3/4-inch arbor spindle. No shank is included; a separate arbor or mounting hardware is required for installation.

Installation Notes

Installation should be performed by a qualified technician or machinist familiar with abrasive wheel mounting procedures. Always disconnect and lock out power to the grinder before mounting or removing the brush. Verify that the machine spindle speed does not exceed the 8,000 RPM maximum rating of the brush before operation. Wear appropriate PPE including eye protection and gloves when operating wire wheel brushes.