Value Collection R83922836 No. 12 Flat Head Phillips Sheet Metal Screw

Product Description

The VALUE COLLECTION R83922836 is a No. 12 flat head Phillips drive sheet metal screw designed for fastening sheet metal, thin-gauge steel, and similar materials in HVAC, electrical, and general trade applications. Manufactured from grade 18-8 stainless steel, this screw delivers corrosion resistance suitable for both interior and exterior installations. The flat head profile sits flush with the work surface when driven, and the Phillips drive allows for fast installation with standard power tools. Overall length is 1.25 inches. These screws are sold in a minimum order quantity of 100 units, making them well suited for contractors and service techs who keep job-site stock on hand.

Commonly used by HVAC technicians to secure duct panels, electrical contractors for enclosure work, and plumbers and general tradespeople for light-gauge metal assembly. The No. 12 thread size is a workhorse diameter in sheet metal and light structural fastening. The 18-8 stainless steel construction makes this screw appropriate for installations where moisture exposure or mild corrosive environments are a concern, including rooftop equipment, outdoor enclosures, and mechanical rooms.

Key Features

• Grade 18-8 stainless steel construction for corrosion resistance in damp or outdoor environments
• Flat head profile seats flush with the material surface for a clean, low-profile finish
• Phillips drive compatible with standard No. 2 Phillips bits and power drivers
• No. 12 thread size suitable for sheet metal and light-gauge metal fastening
• 1.25-inch overall length covers typical single and double-layer sheet metal applications
• Available in quantity multiples of 100 for job-site and shop stock replenishment

Compatibility

Designed as a standard No. 12 flat head Phillips sheet metal screw for use in HVAC ductwork, electrical enclosures, and general light-gauge metal assembly applications where an 18-8 stainless steel fastener is required.

Installation Notes

Installation is performed with a No. 2 Phillips bit in a manual or power screwdriver. De-energize any electrical equipment and shut off associated systems before fastening into enclosures or panels. Pilot holes may be required in heavier-gauge material to prevent screw tip damage and ensure proper thread engagement. Follow applicable NEC or IFGC requirements when fastening near electrical wiring or gas equipment.