Value Collection R83922694 No. 8 Flat Head Phillips Sheet Metal Screw

Product Description

The VALUE COLLECTION R83922694 is a No. 8 flat head Phillips drive sheet metal screw manufactured from 18-8 stainless steel. It measures 0.75 inches in overall length and is designed for fastening thin-gauge sheet metal, light steel framing, and metal ductwork or enclosures. The flat head sits flush with the material surface when fully driven, making it the right choice when a low-profile finish is required. The Phillips drive accepts standard Phillips bits for quick installation with a power driver or hand screwdriver. The 18-8 stainless steel construction resists corrosion in moist or outdoor-adjacent environments, which is relevant for HVAC, electrical enclosure, and light mechanical assembly applications.

This screw is used across trade applications where sheet metal components are joined or secured. Common install scenarios include HVAC duct fabrication and access panel attachment, electrical enclosure assembly, and general light-gauge metal fastening on both residential and commercial job sites. It is sold in minimum order quantities of 100 pieces per order, making it practical for contractors who work through screws at volume on active projects.

Key Features

• No. 8 thread size with 0.75-inch overall length for light-gauge sheet metal fastening
• Flat head profile sits flush with the material surface after installation
• Phillips drive compatible with standard bits and power drivers
• 18-8 stainless steel construction provides corrosion resistance in damp or outdoor-adjacent environments
• Inch measurement system; dimensions are straightforward to match against standard fastener charts

Compatibility

Designed as a standard No. 8 flat head Phillips sheet metal screw suitable for light-gauge steel, sheet metal ductwork, metal enclosures, and similar thin-material fastening applications where a flush-seating head is required.

Installation Notes

Sheet metal screws of this type are installed by HVAC technicians, electricians, and sheet metal workers as part of duct assembly, panel attachment, and enclosure work. Power down or de-energize any electrical enclosure before fastening hardware to it. Use the correct Phillips bit size to avoid cam-out and head damage, particularly in stainless steel, which is susceptible to galling if over-driven. Follow applicable code requirements for fastener spacing on ductwork per SMACNA or local mechanical code guidelines.