Value Collection R83922642 No. 6 Flat Head Phillips Screw

Product Description

The VALUE COLLECTION R83922642 is a No. 6 flat head Phillips drive sheet metal screw designed for fastening sheet metal, light gauge steel, and similar thin-material assemblies. Manufactured from 18-8 stainless steel, this screw offers solid corrosion resistance, making it a reliable choice in environments exposed to moisture or mild chemicals. At 5/8 inches overall length, it is well suited for shallow-thickness applications where a low-profile flat head is required to sit flush with or below the work surface. Electricians, HVAC technicians, and sheet metal workers reach for this fastener during panel assembly, ductwork fabrication, and equipment enclosure work.

This screw is commonly used in light-gauge sheet metal fabrication and HVAC duct assembly, as well as electrical panel and enclosure installations. The flat head profile allows the fastener to countersink flush into the material, which is important where clearance is tight or where a smooth finished surface is required. The Phillips drive is compatible with standard power drivers and hand tools found on any trade job site. This SKU is sold as a single piece with a minimum order quantity of 100 units, making it appropriate for supply stocking, service van restocking, or bulk project procurement.

Key Features

• No. 6 thread size for light-gauge sheet metal applications
• 5/8 inch overall length for shallow-material fastening
• Flat head profile countersinks flush with the work surface
• Phillips drive compatible with standard power and hand drivers
• 18-8 stainless steel construction provides corrosion resistance
• Sold individually with a minimum order quantity of 100 units

Compatibility

Designed as an OEM-style replacement and general-use fastener for No. 6 flat head Phillips sheet metal screw applications in HVAC, electrical, and light fabrication work.

Installation Notes

Sheet metal screws should be installed by qualified trade professionals following applicable codes including NEC for electrical enclosure work or SMACNA standards for ductwork. Ensure the substrate material is properly supported before driving to avoid deformation. Use a Phillips driver bit matched to the screw size to prevent cam-out and head damage. Do not over-torque, as 18-8 stainless fasteners can gall or shear if driven with excessive force.