Value Collection R83922421 Size 14 Pan Head Phillips Screw

Product Description

The VALUE COLLECTION R83922421 is a size 14 pan head Phillips sheet metal screw manufactured from 18-8 stainless steel. The fastener measures 0.5 inches in length under the head and is designed for driving into sheet metal substrates without a pre-tapped hole. The pan head profile provides a wide bearing surface and low-profile seat, while the Phillips drive allows for high torque application with standard tooling. The 18-8 stainless steel construction delivers corrosion resistance suited to environments where moisture or chemical exposure is a concern. This screw is used by HVAC technicians, plumbers, electricians, and sheet metal workers in both field and shop settings.

This fastener is appropriate for use in light-gauge sheet metal assemblies, HVAC ductwork fabrication, electrical enclosure installation, and general trade applications requiring a corrosion-resistant fastener. The pan head and Phillips drive combination is one of the most common configurations in commercial and residential mechanical work, making this screw a standard addition to a service van or shop stock. It is sold in minimum order quantities of 100 pieces per package.

Key Features

• Size 14 thread cuts directly into sheet metal without pre-tapping
• Pan head profile provides wide bearing surface and flush-friendly seating
• Phillips drive compatible with standard hand and power drivers
• 18-8 stainless steel construction resists corrosion in wet and humid environments
• 0.5 inches length under head suits light-gauge sheet metal applications
• Inch measurement system for compatibility with standard US trade fastener specs

Compatibility

Designed as a standard size 14 pan head Phillips sheet metal screw for use in light-gauge sheet metal assemblies common to HVAC, electrical, and plumbing trade work.

Installation Notes

Installation is performed with a Phillips-tip screwdriver or power driver set to appropriate clutch depth to avoid stripping the drive or over-driving into thin sheet metal. Power down any electrical panels or HVAC units before fastening enclosures or access panels. No pilot hole is required for standard light-gauge sheet metal, but a pilot may be used in heavier gauges to prevent material distortion. Follow applicable codes such as SMACNA standards for ductwork fastener spacing.