Value Collection R83922369 Sheet Metal Screw No. 10

Product Description

The VALUE COLLECTION R83922369 is a No. 10 flat head Phillips sheet metal screw manufactured from Grade 18-8 stainless steel. At 5/8 inches in overall length, this fastener is sized for light-gauge sheet metal work where a flush-seated, countersunk profile is required. The flat head design seats flush with or below the material surface when driven into a pre-drilled or self-tapping application. Grade 18-8 stainless steel provides solid corrosion resistance, making this screw suitable for both indoor and outdoor installations where moisture exposure is a concern. This item is sold in a package quantity of 1 with a minimum order quantity of 100 units.

This screw is used across a wide range of trade applications including HVAC ductwork assembly, sheet metal enclosure fabrication, electrical panel work, and light structural sheet metal fastening. The Phillips drive is compatible with standard power drivers and manual screwdrivers. The No. 10 thread size and 5/8-inch length make it a common choice for joining thin sheet metal panels, flanges, and covers in residential and light commercial settings.

Key Features

• Grade 18-8 stainless steel construction for corrosion resistance in wet or humid environments
• Flat head profile seats flush with the material surface for a clean, low-profile finish
• Phillips drive compatible with standard No. 2 Phillips bits and manual drivers
• No. 10 thread size suited for light-gauge sheet metal fastening applications
• 5/8-inch overall length for use in thin sheet metal assemblies and panel covers
• Sold in multiples of 100 units to support job-site and shop inventory needs

Compatibility

Designed as a standard No. 10 flat head Phillips sheet metal screw suitable for general light-gauge sheet metal fastening across HVAC, electrical, and fabrication applications.

Installation Notes

Sheet metal screws of this type are typically installed by HVAC technicians, electricians, and sheet metal fabricators using a No. 2 Phillips bit in a power driver or manual screwdriver. Pre-drilling a pilot hole is recommended when working with heavier gauges to prevent material distortion. Ensure the workpiece is secure and power is shut off before fastening near any energized panels or enclosures. Do not overtorque, as stainless steel fasteners can be susceptible to galling when driven at high speed without lubrication.