Value Collection R63643648 No. 10 Sheet Metal Screw

Product Description

The VALUE COLLECTION R63643648 is a No. 10 round head Phillips sheet metal screw manufactured from Grade 18-8 stainless steel. Designed for fastening sheet metal and light-gauge materials, this screw delivers reliable corrosion resistance in wet, coastal, or chemically active environments. The round head profile provides a low-profile bearing surface, and the Phillips drive allows for quick installation with standard screwdrivers or power tools. At 1 inch measured under the head, it is sized for typical HVAC panel, ductwork, electrical enclosure, and sheet metal fabrication applications. Corrosion resistance and material grade make it a dependable choice for both indoor and outdoor installations where rust resistance is a priority.

This screw is suited for trade professionals who work with sheet metal assemblies in HVAC, electrical, plumbing, and general fabrication work. It is commonly used to secure access panels, junction box covers, duct flanges, and light sheet metal brackets. The No. 10 thread size is a standard choice for sheet metal gauges ranging from light to medium, and the Phillips drive is compatible with widely available hand and power tools found on any service truck or job site.

Key Features

• Grade 18-8 stainless steel construction for strong corrosion resistance
• No. 10 thread size suits a wide range of sheet metal gauges
• 1-inch length under head for secure engagement without over-penetration
• Round head provides a broad bearing surface on thin materials
• Phillips drive compatible with standard hand tools and power drivers
• Inch measurement system for straightforward sizing on standard job sites

Compatibility

Designed as a standard No. 10 sheet metal screw for use in HVAC panels, electrical enclosures, ductwork assemblies, and general light-gauge sheet metal fabrication requiring corrosion-resistant fasteners.

Installation Notes

Sheet metal screws of this type are installed by electricians, HVAC technicians, plumbers, and sheet metal fabricators. Power down or de-energize any electrical enclosure or HVAC unit before fastening panels or covers. Use a properly sized Phillips bit to avoid cam-out and head damage. Pre-drilling a pilot hole is recommended in harder or thicker gauge materials to prevent material distortion and ensure thread engagement.