Value Collection R63640320 No. 6 Oval Head Sheet Metal Screw

Product Description

The VALUE COLLECTION R63640320 is a No. 6 oval head sheet metal screw designed for fastening thin-gauge metal in HVAC, electrical, and general sheet metal fabrication applications. The Phillips drive allows for quick installation with standard hand or power tools. Built from Grade 18-8 stainless steel, this screw resists corrosion in humid and outdoor-exposed environments. The overall length is 3/8 inches, making it well suited for light-gauge panel work, junction box covers, ductwork flanges, and similar sheet metal assemblies. Licensed trades and skilled fabricators install these fasteners as part of routine assembly and service work.

This screw is commonly used in residential and light commercial HVAC duct fabrication, electrical enclosure assembly, and sheet metal panel installations. The oval head profile sits slightly above the surface for a finished appearance while maintaining a low-profile fit under cover panels. The Phillips drive is compatible with standard No. 2 Phillips bits. These fasteners are sold in minimum order quantities of 100 units per order, making them appropriate for contractors and shop environments that require consistent, bulk fastener supply.

Key Features

• Grade 18-8 stainless steel construction for corrosion resistance in humid and outdoor-exposed environments
• Oval head profile provides a finished appearance with a low surface projection
• Phillips drive compatible with standard No. 2 Phillips bits and power drivers
• 3/8 inch overall length suited for light-gauge sheet metal fastening applications
• No. 6 thread size fits standard sheet metal punched or pilot holes for this screw diameter

Compatibility

Designed as a standard No. 6 oval head Phillips sheet metal screw for use in light-gauge sheet metal assembly across HVAC, electrical, and general fabrication applications.

Installation Notes

Sheet metal screws are installed by qualified HVAC technicians, electricians, and sheet metal fabricators. Always ensure the work surface is de-energized before fastening electrical enclosures or duct panels. Use the correct pilot hole size for the gauge of metal being fastened to prevent stripping or cracking. A No. 2 Phillips bit is the standard driver for this screw type.