Value Collection R63099224 Machine Screw 1/4-20 Oval Slotted Brass

Product Description

The VALUE COLLECTION R63099224 is a 1/4-20 x 1 inch brass machine screw with an oval head and slotted drive. It follows the Unified National Coarse (UNC) thread standard and is manufactured to inch-system dimensions. The oval head profile sits partially countersunk, providing a low-profile finished appearance on the mating surface. A bright, uncoated finish is standard, leaving the natural brass material exposed. This fastener is used by maintenance technicians, electricians, plumbers, and general tradespeople when a corrosion-resistant, non-magnetic fastener is required in a threaded assembly.

This screw is suited for light-duty fastening applications in HVAC enclosures, electrical panels, plumbing fixtures, and general equipment assemblies where brass is specified for corrosion resistance or conductivity considerations. The slotted drive is compatible with standard flathead screwdrivers. Overall length is 1 inch, and length under the head is also 1 inch, measured per inch-system standards. No washer is included or required by the design. This screw is sold individually, with a minimum order quantity of 10 units.

Key Features

• 1/4-20 UNC thread for broad compatibility with standard inch-system tapped holes
• Oval head profile provides a low-profile countersunk appearance without full flush seating
• Slotted drive works with standard flathead screwdrivers — no specialty tools required
• Brass construction offers corrosion resistance and non-magnetic properties
• Bright, uncoated finish preserves natural brass appearance
• 1 inch overall length with 1 inch length under the head

Compatibility

Designed as a standard inch-system UNC machine screw suitable for use in any application requiring a 1/4-20 tapped hole with an oval head slotted fastener.

Installation Notes

Install using a flathead screwdriver sized to the slotted head. De-energize and lock out any electrical equipment before fastening into panels or enclosures per applicable NEC requirements. Do not overtighten brass fasteners, as the material is softer than steel and susceptible to thread stripping. Ensure the receiving material has a properly tapped 1/4-20 thread before installation.