Value Collection R6-32X3/8 6-32 Pan Head Machine Screw 10pk

Product Description

The VALUE COLLECTION R6-32X3/8 is a 6-32 UNC pan head machine screw with a built-in silicone O-ring, designed to create a leak-resistant seal at the fastener head. Constructed from 18-8 stainless steel with a bright uncoated finish, this screw offers solid corrosion resistance in wet or humid environments. The 3/8-inch length under head and No. 2 Phillips drive make it a practical choice for light-duty mechanical assemblies where both fastening and sealing are required in a single component. Sold in a package of 10, it suits service technicians and tradespeople who need reliable hardware in small quantities.

This screw is commonly used in HVAC, plumbing, electrical enclosure, and general mechanical applications where preventing moisture or fluid ingress at a fastener point is necessary. The silicone O-ring seats against the mating surface as the screw is driven, compressing to form a seal without a separate gasket. Typical install scenarios include panel covers, access doors, junction boxes, and equipment housings exposed to condensation or washdown conditions.

Key Features

• Integrated silicone O-ring provides a head-seat seal without a separate gasket
• 18-8 stainless steel construction resists corrosion in humid and wet environments
• 6-32 UNC thread form for wide compatibility with standard tapped holes and threaded inserts
• Pan head profile with No. 2 Phillips drive for standard screwdrivers and bits
• Bright uncoated finish — no coating to chip, flake, or interfere with conductivity at contact points
• Pack of 10 suits service call quantities and small repair jobs

Compatibility

Designed for use in any standard 6-32 UNC tapped hole application where a sealing fastener is required, including panel assemblies, enclosures, and equipment covers across HVAC, electrical, and plumbing trades.

Installation Notes

De-energize or shut off the equipment being serviced before removing or installing fasteners on electrical enclosures or mechanical panels. Drive with a No. 2 Phillips screwdriver or bit, seating the screw until the O-ring is visibly compressed against the mating surface — do not overtighten, as excessive torque can damage or extrude the O-ring and compromise the seal. Verify thread engagement depth is sufficient for the application before final tightening.