Value Collection R58005068 Sheet Metal Screw 14 Phillips

Product Description

The VALUE COLLECTION R58005068 is a No. 14 pan head sheet metal screw with a Phillips drive, manufactured from Grade 316 stainless steel with an uncoated finish. Measuring 1.5 inches under the head, this fastener is built for corrosion resistance in demanding environments where moisture, salt, or chemicals are present. Grade 316 stainless steel offers superior resistance compared to standard 304-grade fasteners, making it a reliable choice for outdoor, marine, and industrial applications. Electricians, HVAC technicians, and general contractors use these screws when securing sheet metal panels, ductwork, junction boxes, and equipment enclosures.

This screw is suited for light-gauge sheet metal assembly in both residential and commercial settings. Common applications include securing HVAC duct sections, metal electrical enclosures, roofing trim, marine hardware, and coastal or high-humidity installations where standard carbon steel fasteners would corrode prematurely. The pan head profile provides a wide bearing surface without sharp edges, making it appropriate for exposed metal-to-metal connections. Sold in minimum order quantities of 25 per order.

Key Features

• Grade 316 stainless steel construction for superior corrosion resistance in wet and marine environments
• No. 14 thread size with 1.5-inch length under head for reliable engagement in light-gauge sheet metal
• Pan head profile distributes clamping load over a wide surface area
• Phillips drive for compatibility with standard power and hand tools
• Uncoated finish — no plating to chip or flake under torque or vibration
• Inch measurement system; UNSPSC Code 31161506

Compatibility

Designed for use in standard light-gauge sheet metal fastening applications where a No. 14 pan head Phillips sheet metal screw is specified.

Installation Notes

Sheet metal screws of this type are typically installed by HVAC technicians, electricians, and sheet metal workers using a Phillips-bit driver or drill driver set to an appropriate clutch setting to avoid stripping the drive. Power down or de-energize any electrical enclosures or HVAC equipment before fastening to avoid injury. Pre-drilling a pilot hole is recommended in heavier-gauge metal to reduce fastener stress and ensure proper seating. Follow applicable codes including NEC and SMACNA guidelines for sheet metal work when used in electrical or HVAC assemblies.