Value Collection R55000060 No. 14 Self Drilling Screw

Product Description

The VALUE COLLECTION R55000060 is a No. 14 self drilling screw with a pan head and Phillips drive, designed for direct fastening into metal substrates without a pre-drilled pilot hole. Built from Grade 410 stainless steel, it offers reliable corrosion resistance in demanding trade environments. The screw features a No. 3 drill point for clean penetration and measures 1.5 inches under the head. It is sold in lots of 100 and is a standard choice for HVAC sheet metal work, electrical enclosures, and light structural metal fabrication where a flush, low-profile head is required.

This screw is suited for residential and commercial applications where fastening into light-gauge steel is required. Typical installation scenarios include ductwork assembly, electrical panel fabrication, equipment enclosures, and metal framing connections. The pan head profile distributes clamping load across a wider bearing surface, making it appropriate for thin-gauge sheet metal where pull-through resistance matters. No. 14 sizing suits medium-load fastening points common in HVAC and electrical trade work.

Key Features

• No. 3 drill point for self-drilling into light-gauge metal without pre-drilling
• Grade 410 stainless steel construction for corrosion resistance
• Pan head profile provides a wide bearing surface on thin sheet metal
• Phillips drive for compatibility with standard bit sets
• 1.5-inch length under head suits medium-depth fastening applications
• No. 14 screw size for medium-load metal-to-metal connections

Compatibility

Designed as an OEM-style replacement and general-use fastener for light-gauge metal assemblies in HVAC, electrical, and sheet metal fabrication applications.

Installation Notes

Self drilling screws of this type are installed by HVAC technicians, sheet metal workers, and electricians using a standard Phillips bit in a power drill or screw gun. Confirm substrate gauge is within the rated capacity of a No. 3 drill point before installation. Use appropriate personal protective equipment when working with sheet metal edges. Fastener selection should comply with applicable mechanical and electrical codes for the installation type.