Value Collection R55000034 No. 8 Pan Head Self Drilling Screw

Product Description

The VALUE COLLECTION R55000034 is a No. 8 pan head self drilling screw designed for fastening applications where pre-drilling is not practical. The 2-point drill tip bores through material and taps its own thread in a single operation. Constructed from Grade 410 stainless steel, this screw offers good corrosion resistance and mechanical strength suited for light-gauge metal and similar substrates. The Phillips drive pan head provides positive driver engagement and a low-profile seating surface. At 2 inches length under head, it delivers adequate thread engagement for standard sheet metal and light structural connections.

This screw is suited for use in HVAC ductwork fabrication, sheet metal enclosures, electrical panels, equipment housings, and general trade assembly work. The self drilling point eliminates a separate drilling step, making it practical for field installation where speed and efficiency matter. Grade 410 stainless steel construction makes it appropriate for environments with moderate moisture exposure. These screws are sold in multiples of 100 per minimum order and are typically used in volume fastening applications on commercial and residential mechanical systems.

Key Features

• No. 2 drill point self drills and taps in one pass, no pilot hole required
• Grade 410 stainless steel construction for corrosion resistance in damp or outdoor-adjacent installations
• Pan head profile provides a broad bearing surface and low-profile finish
• Phillips drive for compatibility with standard power drivers and hand tools
• 2 inches length under head suits standard light-gauge sheet metal fastening depths
• No. 8 screw size is a common trade standard for sheet metal and HVAC applications

Compatibility

Designed as a standard No. 8 self drilling pan head screw suitable for light-gauge sheet metal, HVAC ductwork, electrical enclosures, and general mechanical assembly requiring a stainless steel fastener.

Installation Notes

Self drilling screws should be driven with a variable-speed drill or power driver set to an appropriate clutch torque to avoid stripping the drive or over-penetrating thin material. Verify that the substrate thickness is within the rated capacity of the drill point before driving. Follow applicable codes for fastener spacing and material compatibility when used in structural or code-required assemblies. Always wear appropriate eye protection when driving self drilling fasteners at speed.