Value Collection R55000016 No. 6 Self Drilling Screw

Product Description

The VALUE COLLECTION R55000016 is a No. 6 pan head self drilling screw designed for fast, reliable fastening in metal and light-gauge sheet applications. It features a Phillips drive and a No. 2 drill point that cuts its own pilot hole, eliminating the need for pre-drilling in many common installations. The screw measures 5/8 inches in length under the head and is manufactured from Grade 410 stainless steel, providing solid corrosion resistance for both interior and exposed exterior environments. Electricians, HVAC technicians, and general trade professionals use this fastener where speed and corrosion resistance are both required.

This screw is well suited for light commercial and residential trade work including sheet metal ductwork attachment, electrical panel and enclosure assembly, and light structural bracketing. The pan head profile sits flat and distributes clamping load evenly across the fastened surface. The No. 2 drill point is appropriate for thin-gauge metal substrates typical in HVAC and electrical rough-in work. Sold in minimum order quantities of 100 pieces per lot.

Key Features

• No. 2 drill point cuts its own pilot hole — no pre-drilling required on thin-gauge metal
• Pan head profile provides broad bearing surface and low-profile sit
• Phillips drive for compatibility with common power drivers and hand tools
• Grade 410 stainless steel construction for corrosion resistance in damp or exposed conditions
• 5/8 inch length under head suits thin-gauge sheet metal fastening applications
• Inch measurement system — standard sizing for North American trade use

Compatibility

Designed as a standard No. 6 self drilling fastener for use in light-gauge sheet metal, metal framing, and similar thin-substrate applications common in HVAC, electrical, and general trade work.

Installation Notes

This screw is installed by licensed electricians, HVAC sheet metal technicians, and general trade contractors using standard Phillips-tip power drivers or hand screwdrivers. Verify substrate gauge compatibility with the No. 2 drill point before driving — this point is rated for thin-gauge metal and is not intended for heavy structural steel. Apply consistent, controlled driver speed to avoid stripping the Phillips recess or overdriving the fastener through thin sheet material. De-energize any electrical panels or live equipment before fastening in proximity to live conductors.