Value Collection R52001056 Fender Flat Washer 1/4 in 18-8 Ss

Product Description

The VALUE COLLECTION R52001056 is a fender flat washer designed for 1/4 inch screw sizes and manufactured from Grade 18-8 stainless steel. Fender washers feature a larger-than-standard outside diameter relative to their inside diameter, spreading clamp load over a wider surface area. This makes them well suited for applications where the bearing surface is soft, oversized, or prone to pull-through. With a 9/32 inch inside diameter, 1-1/4 inch outside diameter, and 0.05 inch thickness, this washer provides reliable load distribution without adding excessive stack height. The 18-8 stainless steel construction offers good corrosion resistance in mild to moderate environments.

These washers are used across a wide range of trade and light industrial applications including HVAC equipment mounting, plumbing fixture fastening, electrical panel work, and pool equipment installation. The larger OD makes them especially practical when fastening through sheet metal, thin panels, rubber gaskets, or other compressible materials where a standard flat washer would not provide adequate bearing area. They are sold in minimum order quantities of 100 pieces per order.

Key Features

• Grade 18-8 stainless steel construction for corrosion resistance in general service environments
• 9/32 inch inside diameter fits standard 1/4 inch screws and bolts
• 1-1/4 inch outside diameter spreads clamp load over a wide bearing surface
• 0.05 inch thickness provides a low-profile, consistent seat
• Inch measurement system for compatibility with standard fastener tooling
• UNSPSC Code 31161807 for procurement and cataloging use

Compatibility

Designed for use with 1/4 inch screws and bolts in inch-standard fastener applications across HVAC, plumbing, electrical, and pool service installations.

Installation Notes

Install using standard hand or power tools appropriate for 1/4 inch fasteners. Ensure the washer seats flat against the bearing surface before torquing the fastener. De-energize electrical systems and shut off water or gas supply before beginning any fastening work on live equipment. Do not mix stainless steel fasteners with dissimilar metals in environments prone to galvanic corrosion without appropriate isolation.