Value Collection R52000949 No. 10 Self Drilling Screw

Product Description

The VALUE COLLECTION R52000949 is a No. 10 pan head self drilling screw designed for fast, reliable fastening without a pre-drilled pilot hole. Built from 1016/1024 grade steel with a zinc-plated finish for corrosion resistance, this screw features a Phillips drive and a No. 2 drill point. The length under head measures 1.5 inches. It is commonly installed by HVAC technicians, electricians, plumbers, and general contractors when securing sheet metal, light structural members, or equipment panels in both residential and light commercial applications.

This screw is suited for use in sheet metal fabrication, ductwork assembly, equipment enclosures, and general trade construction tasks. The pan head profile distributes clamping load evenly across the fastened surface, making it appropriate for thin-gauge metal and sheet applications where a low-profile, broad-bearing head is required. Sold in a minimum order quantity of 100 units per order.

Key Features

• No. 2 drill point allows self-drilling into sheet metal without a pilot hole
• Pan head profile provides broad bearing surface and low-profile installation
• Phillips drive for compatibility with standard power drivers and hand tools
• 1016/1024 steel construction meets AISI, ASME B18.6.3, ASME B18.6.4, and SAE J78 standards
• Zinc-plated finish provides corrosion resistance in typical indoor trade environments
• Inch measurement system with 1.5-inch length under head

Compatibility

Designed as a standard No. 10 pan head self drilling screw suitable for use in sheet metal, ductwork, equipment enclosures, and light structural applications where a No. 2 drill point and Phillips drive are specified.

Installation Notes

Installation is performed with a standard Phillips bit driver set to appropriate clutch depth to avoid overdriving the screw or stripping the head. Ensure the workpiece material gauge is within the rated capacity of a No. 2 drill point before driving. No pilot hole is required, but proper alignment and steady pressure during initial engagement prevents bit walking. Follow applicable codes and manufacturer guidelines for fastener spacing and load requirements.