Value Collection R50000319 No. 10 Pan Head Phillips Screw

Product Description

The VALUE COLLECTION R50000319 is a No. 10 pan head sheet metal screw designed for fastening light-gauge sheet metal and similar thin materials. The Phillips drive and Type AB point make it easy to start without a pilot hole in most applications. At 3 inches in length under head, this screw provides solid engagement in standard sheet metal assemblies. Manufactured from Grade 2 steel with a zinc finish, it resists corrosion in typical indoor and light-duty outdoor service environments. This fastener is a workhorse item for HVAC techs, electricians, and sheet metal workers on production and service jobs alike.

This screw is suited for residential and light commercial applications where No. 10 sheet metal fasteners are specified. Common uses include securing ductwork panels, electrical enclosure covers, junction box covers, equipment access panels, and general sheet metal fabrication. The pan head profile keeps a low, broad bearing surface that distributes clamping force across thin material without pulling through. Sold per single package with a minimum order quantity of 100 pieces, making it practical for stocking in a service vehicle or shop.

Key Features

• Type AB point starts without a pre-drilled pilot hole in light-gauge sheet metal
• Pan head profile spreads clamping load to reduce pull-through in thin materials
• Phillips drive is compatible with standard power drivers and hand tools
• Zinc finish provides corrosion resistance for general indoor and light-duty service
• Grade 2 steel construction meets typical fastener strength requirements for sheet metal work
• 3-inch length under head suits panels and assemblies requiring deeper thread engagement

Compatibility

Designed as an OEM-style replacement or standard-stock fastener for No. 10 sheet metal screw applications in HVAC ductwork, electrical enclosures, and general light-gauge sheet metal assemblies.

Installation Notes

Sheet metal screws are installed by licensed HVAC technicians, electricians, and sheet metal mechanics following applicable trade codes. Power down or de-energize any electrical enclosure or equipment before fastening access panels or covers. Use a Phillips-tip driver bit matched to the screw head size to avoid cam-out and head damage. Do not overtighten — drive until the head seats flush against the material surface.