Value Collection PC127NB-4 Brass Street Tee 1/4 in

Product Description

The VALUE COLLECTION PC127NB-4 is a 1/4 inch brass pipe street tee designed for use in pressurized fluid and gas piping systems. It features a female NPT (FNPT) inlet on one end and a male NPT (MNPT) outlet on the run, allowing it to branch a line without requiring an additional nipple at the street connection. The fitting carries a 1,000 psi pressure rating and is finished in nickel plating to resist corrosion and provide a clean appearance. At 0.14 pounds, it is a compact, lightweight component suited for tight plumbing assemblies. Plumbers, HVAC technicians, and pipefitters commonly install this type of fitting in both residential and light commercial piping configurations.

This street tee is appropriate for use in water supply, compressed air, and compatible fluid distribution systems where a 1/4 inch branch connection is needed. The FNPT x MNPT end configuration allows the fitting to thread directly into a tee position on an existing run without an extra close nipple, saving space in confined installations. It is well suited for instrumentation lines, pressure gauge ports, and small-bore branch takeoffs commonly found in HVAC equipment, plumbing panels, and compressed air distribution.

Key Features

• 1/4 inch fitting size for small-bore piping applications
• FNPT x MNPT end connections allow direct street installation without an extra nipple
• 1,000 psi pressure rating suitable for water, air, and compatible fluid service
• Nickel-plated finish over brass construction for corrosion resistance
• Lightweight at 0.14 pounds for use in tight or weight-sensitive assemblies

Compatibility

Designed as a standard-thread replacement or addition fitting for 1/4 inch NPT piping systems in residential and light commercial plumbing, HVAC, and compressed air applications.

Installation Notes

Installation is typically performed by a licensed plumber or pipefitter. Shut off and depressurize the system fully before removing or installing any threaded fittings. Apply an appropriate thread sealant or PTFE tape to the male threads before assembly and tighten to hand-snug plus a firm wrench turn, taking care not to over-torque brass fittings. Verify all connections are leak-free under system pressure before returning the line to service.