Value Collection P20215 Clevis Pin 5/16 in Stainless

Product Description

The VALUE COLLECTION P20215 is a standard clevis pin machined from 18-8 stainless steel with an uncoated finish. It measures 0.3125 inches in pin diameter and 1.625 inches in overall length, with a usable length of approximately 1.484 inches. The through-hole diameter is 0.140625 inches, sized to accept a standard cotter pin or snap ring for positive retention. This fastener is used to create a pivoting connection in clevis-style linkages and is installed by maintenance technicians, millwrights, and mechanical tradespeople across a wide range of equipment applications.

This clevis pin is suited for use in light-duty mechanical linkages where a removable pivot fastener is required. Common applications include HVAC actuator linkages, control rod assemblies, and general equipment maintenance where stainless steel corrosion resistance is preferred over plated carbon steel alternatives. The 18-8 stainless alloy provides adequate strength and resistance to moisture and mild chemical exposure in both indoor and outdoor service environments.

Key Features

• 18-8 stainless steel construction for corrosion resistance in wet or outdoor environments
• Uncoated finish — no plating to chip, flake, or contaminate a joint
• 0.3125-inch pin diameter for use in standard 5/16-inch clevis bores
• 0.140625-inch cross-hole accepts standard cotter pins or snap rings for secure retention
• 1.484-inch usable length accommodates typical clevis jaw widths without excessive overhang

Compatibility

Designed as an OEM-style replacement or service spare for mechanical linkages requiring a 5/16-inch diameter clevis pin in stainless steel with a 9/64-inch retention hole.

Installation Notes

Installation is performed by qualified mechanical technicians or maintenance personnel. De-energize and lock out any actuator, cylinder, or mechanism connected to the linkage before removing or inserting the clevis pin. Insert the pin fully through the clevis bore and usable length, then secure the cross-hole with a cotter pin or snap ring — never leave the retention hole unoccupied under load. Inspect the mating clevis bore for wear or elongation before installing a replacement pin.