Value Collection OGFWIS062G Ogee Washer 5/8 in Cast Iron

Product Description

The VALUE COLLECTION OGFWIS062G is a cast iron ogee washer designed for use in structural and heavy-duty fastening applications. This washer features a curved ogee profile that distributes load evenly across the bearing surface, reducing the risk of pull-through or surface damage under high-clamp-load conditions. It accommodates a 5/8 inch screw size with a 3/4 inch inside diameter and measures 2-3/4 inches in outside diameter and 5/8 inch thick. The hot-dipped galvanized finish provides corrosion resistance suited to outdoor, below-grade, or moisture-prone environments. Installation is typically performed by carpenters, structural contractors, or plumbers working with timber framing, post-anchor systems, or structural connections.

This ogee washer is commonly used in timber construction, post-base connections, anchor bolt assemblies, and structural wood-to-concrete interfaces where a large bearing area is required. The curved radius profile seats against countersunk or curved surfaces typical in timber and masonry applications. Its cast iron construction and galvanized coating make it appropriate for exterior and below-grade structural work where long-term corrosion resistance is a requirement.

Key Features

• Cast iron construction for high compressive strength under structural loads
• Hot-dipped galvanized finish for corrosion resistance in exterior and moisture-prone environments
• 2-3/4 inch outside diameter provides a wide load-bearing surface to prevent pull-through
• 5/8 inch screw size with 3/4 inch inside diameter for standard structural bolt fitment
• 2-3/4 inch radius ogee profile seats correctly against curved or countersunk surfaces
• 5/8 inch thickness adds rigidity under heavy clamping loads

Compatibility

Designed as an OEM-style replacement or standard-fit washer for structural bolt assemblies using 5/8 inch fasteners in timber framing, post-anchor, and concrete anchor bolt applications.

Installation Notes

Installation is typically performed by structural carpenters or contractors following applicable building code requirements. Always ensure the mating surface is clean and free of debris before seating the washer. Verify that the fastener and washer combination meets the load requirements specified in the project drawings or engineering specifications. Do not substitute this washer in applications requiring a different inside diameter or load rating without confirming compatibility with the design engineer.