Value Collection NFC5561 Toggle Bolt Anchor 2550 Lb Steel

Product Description

The VALUE COLLECTION NFC5561 is a steel toggle bolt anchor designed for fastening into hollow wall and drywall substrates where a reliable, high-load connection is required. With a rated maximum load capacity of 2,550 lb and a 1/2 inch diameter bolt paired with a 6 inch overall length, this anchor delivers serious holding power in applications where standard screw-in anchors fall short. The zinc finish provides corrosion resistance for both interior and exposed installations. The slotted/Phillips drive type allows installation with common hand tools or a drill driver. This part is typically installed by electricians, plumbers, HVAC technicians, and general contractors who need secure wall attachment points for equipment, conduit, piping, or ductwork.

This anchor is suited for residential and light commercial installation scenarios where fastening into hollow walls, plaster, wallboard, hollow tile, or concrete and masonry is required. The toggle bolt design expands behind the wall surface to distribute load across a wider area, making it appropriate for hanging heavy equipment brackets, pipe hangers, junction boxes, and similar trade hardware. A minimum order quantity of 10 units makes this anchor practical for stocking on service vehicles or job sites where multiple anchor points are needed.

Key Features

• 2,550 lb maximum load capacity for demanding fastening applications
• 1/2 inch diameter bolt with 6 inch overall length for deep substrate reach
• Steel construction with zinc finish for corrosion resistance
• Slotted/Phillips drive compatible with standard hand tools and drill drivers
• Toggle bolt design distributes load behind hollow wall surfaces
• Suitable for use in concrete/masonry, hollow tile, plaster, and wallboard

Compatibility

Designed for use in concrete and masonry, hollow tile, plaster, and wallboard substrates. Appropriate for residential and light commercial hollow wall fastening applications requiring a 1/2 inch toggle bolt anchor.

Installation Notes

Toggle bolt anchors are installed by folding the toggle wings flat, threading them through a pre-drilled hole, and allowing them to spring open behind the wall cavity before drawing the bolt snug. Always drill the correct hole diameter to match the anchor specification and confirm the wall substrate and thickness before selecting anchor length. De-energize any electrical circuits and shut off relevant utilities before drilling into walls where concealed wiring or piping may be present. Follow applicable building codes and manufacturer load ratings when specifying anchors for structural or equipment-support applications.