Value Collection NFC2413F Hammer Drive Concrete Anchor

Product Description

The VALUE COLLECTION NFC2413F is a hammer drive concrete anchor designed for fast, tool-minimal fastening into concrete, masonry, and block substrates. The anchor features a nylon body with a zinc-plated finish and a flat head profile. At 1/4 inch in diameter and 1-1/2 inches overall length (OAL), it is sized for light- to medium-duty anchorage tasks where a pre-drilled 1/4 inch hole is required. Installation is accomplished by driving the anchor with a hammer after placing it in the pilot hole, expanding the nylon body against the base material for a secure hold. This fastener is commonly installed by electricians, plumbers, HVAC technicians, and general contractors securing conduit straps, pipe hangers, and light fixtures to concrete or block surfaces.

This anchor is suited for residential and light commercial applications where a quick, low-profile fastening solution is needed in concrete, cinder block, or similar masonry. Typical use cases include securing cable management hardware, duct supports, junction box brackets, and other trade hardware to poured concrete floors, walls, and ceilings. The flat head sits flush or near-flush with the work surface, making it appropriate for installations where protrusion must be minimized.

Key Features

• Nylon anchor body provides corrosion resistance in damp or humid environments
• Zinc-plated finish on metal components adds additional corrosion protection
• Flat head profile sits flush with the substrate surface after installation
• 1/4 inch diameter matches standard 1/4 inch masonry drill bit for straightforward hole prep
• 1-1/2 inch OAL suitable for light- to medium-duty anchorage in solid concrete and block
• Hammer-drive installation requires no specialty setting tool

Compatibility

Designed as an OEM-style replacement and general-use hammer drive anchor for light-duty fastening applications in concrete and masonry substrates requiring a 1/4 inch diameter pilot hole.

Installation Notes

Installation should be performed by a qualified tradesperson following applicable building codes. Drill a clean 1/4 inch diameter hole to the required depth using a carbide-tipped masonry bit before inserting the anchor. Ensure the hole is free of debris before driving the anchor flush with a hammer. Do not overdrive, as excess force can crack the nylon body or damage the surrounding substrate.