Value Collection MSC-62148127 Malleable Iron Pipe Bushing

Product Description

The VALUE COLLECTION MSC-62148127 is a malleable iron threaded pipe bushing used to reduce a 1-inch female pipe thread connection down to a 3/4-inch male pipe thread. It is rated for 300 psi on liquid and gas service and 150 psi on steam service, making it suitable for a wide range of mechanical piping systems. The galvanized finish provides corrosion resistance for use in wet or humid environments. Plumbers, pipefitters, and mechanical contractors install this fitting in both new construction and repair applications where pipe size reductions are needed in threaded iron piping systems.

This bushing is used in residential and light commercial plumbing, HVAC hydronic systems, compressed air lines, and gas distribution piping where a 1-inch to 3/4-inch threaded reduction is required. It conforms to Class 150 malleable iron fitting standards and is appropriate for water, air, gas, and steam service within its rated pressure limits. It is a direct-thread hex bushing style installed with a pipe wrench into a 1-inch female-threaded fitting or valve.

Key Features

• Malleable iron construction for strength and resistance to impact in threaded piping systems
• Galvanized finish for corrosion resistance in wet or humid service conditions
• 300 psi liquid and gas pressure rating for reliable service in pressurized systems
• 150 psi steam pressure rating suitable for low-pressure steam applications
• Class 150 fitting standard for compatibility with standard threaded iron piping components
• 1-inch to 3/4-inch reducing configuration for common pipe size transitions

Compatibility

Designed as a standard Class 150 malleable iron threaded hex bushing for use in 1-inch to 3/4-inch NPT threaded piping systems handling liquid, gas, or steam service within rated pressure limits.

Installation Notes

Installation is performed by licensed plumbers or pipefitters following applicable IPC and IFGC code requirements for the service type. Shut off and depressurize the piping system fully before removing or installing any threaded fittings. Apply an appropriate thread sealant or PTFE tape to the male threads before installation and tighten with a pipe wrench to a leak-free fit. Do not exceed the rated pressure or temperature limits for the intended service.