Value Collection MS09B7092 Constant Torque Hose Clamp

Product Description

The VALUE COLLECTION MS09B7092 is a constant torque hose clamp designed to maintain consistent clamping pressure on hose connections as the hose expands and contracts with temperature cycles. Unlike standard worm-drive clamps, constant torque designs use a spring-loaded band that compensates for hose deformation over time, reducing the risk of leaks in demanding service environments. The band is constructed from Grade 304 stainless steel, with a carbon steel screw finished in zinc. The clamp is 5/8 inches wide and weighs 0.03 pounds. It is suited for plumbing, HVAC, and industrial fluid-handling applications where hose integrity under thermal cycling is critical.

This clamp is used on hoses with an outside diameter ranging from 2.75 inches to 3.625 inches. It is commonly installed in residential and light commercial settings on coolant lines, radiator hoses, and flexible pipe connections where maintaining seal integrity over extended service intervals is a priority. Plumbers, HVAC technicians, and mechanical contractors routinely specify constant torque clamps in applications involving silicone, EPDM, or other elastomeric hoses that are prone to creep and compression set.

Key Features

• Constant torque spring-loaded band maintains clamping pressure through thermal expansion and contraction cycles
• Fits hose outside diameters from 2.75 inches to 3.625 inches
• Band width of 5/8 inches distributes clamping load evenly across the hose surface
• Grade 304 stainless steel band resists corrosion in wet and humid environments
• Zinc-finished carbon steel screw provides reliable drive engagement
• Lightweight at 0.03 pounds — suitable for tight installation spaces

Compatibility

Designed as a constant torque replacement clamp for hoses with an outside diameter between 2.75 inches and 3.625 inches. Verify hose outside diameter before installation to confirm fitment.

Installation Notes

Installation is performed by plumbers, HVAC technicians, or mechanical contractors using a standard hex-head or slotted screwdriver. Depressurize and drain the connected fluid system before removing or installing any hose clamp. Position the clamp at least 1/4 inch from the end of the hose fitting to ensure full band contact. Do not overtighten beyond the clamp's rated torque range, as excessive force can damage the hose or distort the band.