Value Collection MS01D64216 Worm Gear Clamp Sae 128

Product Description

The VALUE COLLECTION MS01D64216 is a worm gear clamp rated to SAE Size 128, designed for clamping applications requiring a broad diameter range of 2.5 inches minimum to 8.5 inches maximum. The clamp features a stainless steel band that is 0.5 inches wide, constructed from 201-grade stainless steel for corrosion resistance in wet or chemically active environments. The worm drive mechanism allows precise tightening across the full diameter range, making it suitable for hose, duct, and sleeve connections in plumbing, HVAC, and general mechanical service. Installation is handled by plumbers, HVAC technicians, and mechanical contractors working on pipe and duct assemblies.

This clamp is used across residential and light commercial applications where a wide-range hose or duct clamp is needed. Typical install scenarios include securing flexible duct collars, drain hose connections, coolant hoses, and exhaust sleeves. The wide clamping range of 2.5 to 8.5 inches makes it well suited for large-diameter flexible connections that standard narrow-range clamps cannot accommodate.

Key Features

• SAE Size 128 worm gear clamp with 2.5 to 8.5 inch diameter range
• 201-grade stainless steel band and housing for corrosion resistance
• Band width of 0.5 inches for secure, even clamping pressure
• Worm drive design allows precise incremental tightening
• Lightweight at 0.03 pounds for easy single-hand positioning during install

Compatibility

Designed as a standard SAE 128 worm gear clamp suitable for large-diameter flexible hose, duct, and sleeve connections in plumbing, HVAC, and mechanical applications where a 2.5 to 8.5 inch clamping range is required.

Installation Notes

Install using a flat-blade or hex-drive screwdriver appropriate for the worm gear head. Power down or shut off fluid and air flow to the system before loosening or repositioning clamps on pressurized lines. Tighten evenly to seat the band squarely on the hose or duct surface without overtightening, which can deform thin-wall flexible materials. Follow applicable IPC or IFGC guidelines when used on drain, waste, or gas-adjacent sleeve connections.