Value Collection MPRFI-1001250-100BX Machine Screw 10-32

Product Description

The VALUE COLLECTION MPRFI-1001250-100BX is a 10-32 UNF machine screw with a round head and Phillips drive, sold in a box of 100. The fastener measures 1.25 inches in length under the head and is manufactured from Grade 2 steel with a zinc-plated finish for basic corrosion resistance. These screws follow the Unified National Fine thread standard, making them suitable for close-tolerance metal assembly work. They ship without a washer. Electricians, HVAC technicians, and general mechanical trades use this size regularly for panel covers, equipment housings, and light-duty structural assembly.

The 10-32 thread size is one of the most widely used fastener sizes in electrical enclosures, control panels, HVAC equipment cabinets, and light-duty metal fabrication. The Phillips round head sits above the mating surface and is driven with a standard No. 2 Phillips screwdriver or bit. This box quantity of 100 suits service vehicles, shop stock, and job-site replenishment where consistent supply of a common fastener size is needed.

Key Features

• 10-32 UNF thread for precise, close-tolerance engagement in tapped holes
• 1.25-inch length measured under the head
• Round head profile seats flush to slightly proud of the work surface
• Phillips drive compatible with standard No. 2 bits and screwdrivers
• Grade 2 steel construction with zinc-plated finish for light corrosion protection
• Box of 100 for bench stock, service trucks, or panel shop use

Compatibility

Designed for use in any application requiring a 10-32 UNF round head Phillips machine screw, including electrical enclosures, HVAC cabinet panels, control board mounting, and general light-duty metal assembly.

Installation Notes

A licensed electrician or qualified HVAC technician should de-energize any panel or enclosure before fastener work begins, following applicable NEC lockout/tagout requirements. Use a No. 2 Phillips bit or screwdriver to drive these screws into pre-tapped or threaded insert holes sized for 10-32 UNF. Do not over-torque into thin sheet metal or plastic standoffs, as this can strip the thread engagement. Inspect the mating thread condition before installation to ensure proper fit.