Value Collection IRG-24-BKN Flexible Rubber Grommet

Product Description

The VALUE COLLECTION IRG-24-BKN is a flexible rubber grommet designed to protect wiring, tubing, and hoses where they pass through metal panels, enclosures, and bulkheads. With a 5/8-inch outside diameter and a 3/8-inch inside diameter, this grommet fits a standard panel cutout and shields cables or conduit from sharp edges. The slot diameter is 1/2 inch with a 1/16-inch slot width, allowing the grommet to snap into place without requiring the wire or tubing to be threaded through. Molded from rubber with a Shore hardness of 50 to 60, it provides a secure, vibration-dampening fit. HVAC technicians, electricians, and plumbers install these grommets during panel assembly and service work.

This grommet is suited for use in residential and light commercial applications where low-voltage or signal wiring, refrigerant tubing, or small-diameter conduit passes through sheet metal. Common install scenarios include air handler cabinets, electrical enclosures, control panels, and equipment frames where edge protection and a clean penetration are required. The flexible rubber material allows the grommet to be pressed into a drilled or punched hole without adhesives or additional hardware.

Key Features

• Flexible rubber construction with 50 to 60 Shore hardness for secure panel fit
• 5/8-inch outside diameter and 3/8-inch inside diameter for standard panel cutouts
• 1/2-inch slot diameter with 1/16-inch slot width for snap-in installation
• 1/4-inch overall thickness seats flush in typical sheet metal panels
• Black color for standard visibility in equipment enclosures
• Sold in packages of 100 units

Compatibility

Designed as an OEM-style replacement or new-installation grommet for sheet metal panels, enclosures, and bulkheads requiring a 5/8-inch outside diameter flexible rubber grommet with a 3/8-inch inside diameter.

Installation Notes

This grommet is installed by electricians, HVAC technicians, and plumbers during panel fabrication or equipment service. Power down and de-energize all circuits before working in any electrical enclosure. Press the grommet firmly into the panel cutout until the flange seats against both faces of the sheet metal. Verify the inside diameter is appropriate for the cable or tubing outside diameter before installation to ensure adequate edge protection.