Value Collection HXLI20751000G Hex Lag Screw 3/4x10 in

Product Description

The VALUE COLLECTION HXLI20751000G is a hex head lag screw built for heavy-duty fastening in structural and outdoor applications. Measuring 3/4 inch in diameter with a 10 inch length under head, this screw is manufactured from Grade 2 steel with a hot-dipped galvanized finish that provides corrosion resistance in exposed or moisture-prone environments. The hex head design allows installation with standard wrenches or hex-drive sockets, making it practical for high-torque driving into dense lumber or timber framing. This fastener is a standard choice for contractors, carpenters, electricians, and HVAC technicians securing equipment supports, brackets, and structural members.

This lag screw is suited for residential and commercial applications where a large-diameter, long fastener is required. Typical uses include securing ledger boards, heavy timber connections, wood-to-wood structural joints, equipment mounting pads, and anchor points for brackets and strut channel. The hot-dipped galvanized finish makes it appropriate for exterior installations, pressure-treated lumber applications, and environments with elevated moisture exposure. Sold individually, it is well matched for repair, replacement, or small-quantity fastening tasks on job sites.

Key Features

• 3/4 inch diameter with 10 inch length under head for deep, secure penetration into structural lumber
• Hot-dipped galvanized finish provides durable corrosion resistance for exterior and wet-environment use
• Grade 2 steel construction meets standard structural fastening requirements
• Hex head design compatible with standard wrenches and impact drivers with hex sockets
• Sold as a single unit, suitable for replacement or low-quantity applications

Compatibility

Designed as a standard hex head lag screw for use in wood-to-wood and wood-to-substrate structural connections where a 3/4 inch by 10 inch hot-dipped galvanized fastener is specified.

Installation Notes

Lag screws of this diameter typically require a pilot hole to prevent wood splitting and to allow full thread engagement — consult applicable building codes or engineer specifications for pilot hole sizing. Drive with a properly rated impact wrench or ratchet using the correct hex socket; do not overtighten, as Grade 2 steel has defined tensile limits. When installing into pressure-treated lumber, confirm that the galvanized coating grade meets current building code requirements for contact with treated wood. Follow applicable IBC or local structural codes for fastener spacing and edge distances.