Value Collection FWSIS0-20-10LBBX Sae Flat Washer

Product Description

The VALUE COLLECTION FWSIS0-20-10LBBX is a Number 2 screw size SAE flat washer manufactured from steel with a zinc-plated finish. This washer meets ASME B18.21.1 standards and is used to distribute load under a fastener head or nut, reducing surface damage and preventing pull-through on bolted assemblies. The inside diameter is 3/32 inches, the outside diameter is 7/32 inches, and the thickness is 0.021 inches. The zinc plating provides basic corrosion resistance for general-purpose indoor and light-duty applications. Licensed tradespeople and maintenance professionals install this type of washer across mechanical, electrical, and plumbing assemblies where a standardized SAE washer geometry is required.

This SAE flat washer is suited for residential and light commercial mechanical assemblies, panel work, equipment mounting, and general fastener applications requiring a Number 2 screw size washer. Its SAE profile provides a wider bearing surface than USS washers of the same screw size, making it a practical choice when load distribution across a soft or thin substrate is needed. The inch-measurement dimensions and ASME B18.21.1 compliance make it a direct fit for standard North American fastener specifications.

Key Features

• Meets ASME B18.21.1 standard for SAE flat washers
• Steel construction with zinc-plated finish for corrosion resistance
• Inside diameter of 3/32 inches fits Number 2 screw size fasteners
• Outside diameter of 7/32 inches provides adequate load-bearing surface
• Thickness of 0.021 inches for consistent seating under fastener heads and nuts
• Material Grade 2 steel for general-purpose fastening applications

Compatibility

Designed for use with Number 2 screw size fasteners in assemblies requiring SAE flat washers per ASME B18.21.1 in inch-measurement configurations.

Installation Notes

Install using standard hand tools appropriate for the fastener size. Ensure the washer is seated flat against the substrate before torquing the fastener. No special certifications are required for installation of standard hardware fasteners, though applicable mechanical and electrical codes should be observed for the assembly being serviced.