Value Collection FHS1XX1050-025BX M10x1.5 Flat Socket Cap Screw

Product Description

The VALUE COLLECTION FHS1XX1050-025BX is a metric flat socket cap screw designed for flush or countersunk fastening applications in corrosion-resistant assemblies. Manufactured from 316 austenitic stainless steel to Material Grade A4 per DIN 7991, this fastener delivers reliable performance in wet, chemical, or marine environments. The 90-degree flat head sits flush with the mating surface when fully seated, and the 6.00 mm hex socket drive accepts standard hex keys for controlled installation torque. Thread size is M10x1.5 with a 6G thread fit class, and the fastener is partially threaded with an overall length of 50.00 mm. Licensed trades and industrial maintenance personnel specify this grade for applications where corrosion resistance is a primary design requirement.

This flat socket cap screw is suited for mechanical assemblies, structural connections, and equipment fabrication where a low-profile flush head is required. The partially threaded shank provides a shoulder bearing surface useful in applications with controlled clamp length or where shear loads are distributed across the unthreaded portion. It is commonly used in food processing, marine hardware, chemical processing equipment, and outdoor structural assemblies. The plain finish retains the natural corrosion resistance of the base 316 stainless material without additional coating.

Key Features

• 90-degree flat head profile seats flush with countersunk or flat surfaces per DIN 7991
• 316 austenitic stainless steel, Material Grade A4, for high corrosion resistance in wet and chemical environments
• M10x1.5 thread with 6G fit class ensures consistent thread engagement and interchangeability
• Partially threaded shank with 26.00 mm thread length distributes shear loads along the unthreaded section
• 6.00 mm hex socket drive compatible with standard metric hex keys and bit drivers
• Plain finish preserves inherent stainless steel corrosion resistance without masking surface condition

Compatibility

Designed as a metric DIN 7991 flat socket cap screw compatible with M10x1.5 threaded holes requiring a 90-degree countersunk flat head and a 6G thread fit class.

Installation Notes

Installation is typically performed by millwrights, pipefitters, mechanical contractors, or maintenance technicians using a calibrated hex key or torque wrench with the appropriate 6.00 mm hex bit. Always verify the mating countersink angle is 90 degrees and the hole is clean and free of debris before seating the fastener. Do not over-torque stainless steel fasteners, as galling can occur; use an anti-gall lubricant when specified by the assembly engineer. Power down or de-energize any equipment before fastening or removing hardware in live electrical or mechanical systems.