Value Collection DTKPBI0-60100P-500BX Drywall Screw

Product Description

The VALUE COLLECTION DTKPBI0-60100P-500BX is a size 6 coarse-thread drywall screw built for fastening drywall panels to wood framing. At 1 inch in overall length, this screw is suited for single-layer drywall applications where a shorter fastener is required. The bugle head design countersinks cleanly without tearing the paper face of the board, and the black phosphate finish provides corrosion resistance and reduces surface glare during installation. Constructed from Grade 2 steel, these screws deliver reliable shear strength for standard drywall work. This box contains 500 screws, providing enough quantity for full room installations or restock of a service vehicle.

These screws are used in residential and light commercial drywall installation, including wall and ceiling panel attachment to wood studs. The 1-inch length is typical for single-layer half-inch drywall fastened to wood framing, a common configuration in new construction and remodel projects. Drywall contractors, finish carpenters, and general construction crews are the primary users. The Phillips drive type is compatible with standard drywall screw guns and bit-equipped drills, making these screws straightforward to run at volume on any active job site.

Key Features

• Bugle head countersinks flush without tearing drywall face paper
• Black phosphate finish resists corrosion and reduces bit slippage during drive
• Grade 2 steel construction provides consistent shear and tensile performance
• Phillips drive compatible with standard drywall guns and cordless drills
• 1-inch overall length suited for single-layer drywall-to-wood applications
• 500-count box quantity supports high-volume installation work

Compatibility

Designed as a standard replacement or supply stock fastener for single-layer drywall installation over wood framing in residential and light commercial construction.

Installation Notes

Installation should be performed by qualified drywall installers or general contractors familiar with fastener placement requirements per applicable building codes. Drive screws until the bugle head sits just below the surface of the drywall without breaking through the face paper. Use a drywall screw gun with adjustable clutch depth setting to maintain consistent dimple depth across the panel. Do not overdrive, as this compromises holding strength and creates a larger finishing repair.