Value Collection C52000771 No.10 Self Drilling Screw 25pk

Product Description

The VALUE COLLECTION C52000771 is a No. 10 self drilling screw designed for fast, reliable fastening without a pre-drilled pilot hole. The flat head profile sits flush with the work surface when fully driven. A Phillips drive recess accepts standard No. 2 Phillips bits. The No. 3 drill point bores through the base material and taps its own thread in a single operation. Constructed from Grade 410 stainless steel, this screw resists corrosion in moderately harsh environments. Overall length is 3 inches. Each package contains 25 screws. Installers in HVAC, electrical, and light construction trades reach for this type of fastener when speed and a clean finished surface are both required.

This screw is suited for light-gauge metal-to-metal and metal-to-substrate applications common in HVAC ductwork fabrication, electrical enclosure assembly, sheet metal work, and general trade service calls. The flush-seating flat head makes it a preferred choice wherever a protruding head would interfere with mating panels, covers, or trim pieces. The 3-inch overall length accommodates multi-layer assemblies or situations where additional thread engagement depth is needed for pull-out resistance.

Key Features

• No. 3 drill point self-drills and self-taps in one pass — no pilot hole required
• Flat head profile seats flush with the work surface
• Phillips drive compatible with standard No. 2 bits and power drivers
• Grade 410 stainless steel construction for corrosion resistance
• 3-inch overall length provides deep thread engagement for multi-layer assemblies
• Sold in a 25-count package — suitable for single-job use or restocking a service kit

Compatibility

Designed as a general-purpose No. 10 self drilling screw suitable for light-gauge metal fabrication and assembly applications common in HVAC, electrical, and related trades.

Installation Notes

This screw is typically driven by a licensed sheet metal worker, HVAC technician, or electrician using a power drill or impact driver with a No. 2 Phillips bit. Apply consistent axial pressure to allow the drill point to engage before threading begins — easing pressure too early can cause the point to walk. For electrical enclosures or panels, de-energize all circuits before fastening per NEC guidelines. Do not overdrive; stainless fasteners are subject to galling if torque is applied too aggressively at final seating.