Value Collection C52000671 Machine Screw 12-24 Phillips Ss

Product Description

The VALUE COLLECTION C52000671 is a 12-24 UNC machine screw with a round head and Phillips drive, manufactured from 18-8 stainless steel with a bright, uncoated finish. At 1-1/2 inches in length measured under the head, this fastener delivers corrosion resistance suited to both indoor and outdoor applications. The 18-8 stainless steel grade provides a practical balance of strength, formability, and resistance to rust and mild chemical exposure. Sold in a package quantity of 25, this screw is a standard inch-system fastener with no washer. Electricians, HVAC technicians, plumbers, and general mechanical trades reach for this type of screw when securing panels, brackets, and equipment enclosures.

This machine screw fits typical 12-24 threaded inserts, nuts, and tapped holes found in light-gauge metal assemblies, electrical enclosures, HVAC equipment panels, and plumbing fixture brackets. The round head profile sits above the work surface and distributes clamping load over a modest bearing area, making it appropriate where a low-profile flat head is not required. The Phillips drive is compatible with standard No. 2 Phillips bits and screwdrivers common on every service truck.

Key Features

• 12-24 UNC thread form for compatibility with standard inch-system tapped holes and hex nuts
• Round head with Phillips drive accepts a No. 2 Phillips bit
• 18-8 stainless steel construction resists corrosion in damp and mildly corrosive environments
• Bright, uncoated finish with no added plating or coating
• 1-1/2 inch length measured under head suits medium-depth clamping applications
• Packaged in a quantity of 25 for bench stock and service kit replenishment

Compatibility

Designed for use in any application requiring a 12-24 UNC inch-system machine screw with a round head and Phillips drive in stainless steel.

Installation Notes

De-energize any electrical equipment and follow applicable NEC guidelines before fastening or removing screws in electrical enclosures. Use a properly sized No. 2 Phillips screwdriver or bit to avoid cam-out and fastener damage. Ensure the mating tapped hole or nut matches the 12-24 UNC thread specification before driving. Do not exceed the torque capacity of the 18-8 stainless steel material, as stainless fasteners are susceptible to galling if driven too aggressively without lubrication.