Value Collection BOEC14100wHex Elevator Bolt 1/4-20 Steel

Product Description

The VALUE COLLECTION BOEC14100wHex is a Grade 2 steel elevator bolt with a flat, broad head designed to seat flush against or below the surface of conveyor belting, wood, or similar materials. The 1/4-20 UNC thread and 1 inch overall length make this a compact fastener suited for light-duty conveyor and agricultural equipment assemblies. The uncoated steel finish is standard for interior mechanical applications where additional plating is not required. Licensed tradespeople and equipment maintenance technicians working on conveyor systems, grain handling equipment, and feed machinery will encounter this fastener type routinely.

Elevator bolts are a standard hardware component in bulk-material conveyor systems, grain elevators, and agricultural processing equipment. The wide, flat head distributes clamping load across belting or wooden lagging, preventing pull-through under dynamic load. This fastener is appropriate for residential shop builds, light commercial conveyor assemblies, and agricultural maintenance applications where a 1/4-20 UNC thread pattern is specified. Sold in multiples of 100, this bolt is intended for production assembly or maintenance stock replenishment.

Key Features

• 1/4-20 UNC thread for compatibility with standard nuts and tapped components
• 1 inch overall length suited for thin belting and board assemblies
• 31/32 inch head diameter (0.969 to 1.008 inches) provides broad clamping surface
• Grade 2 steel construction meets general-purpose fastener strength requirements
• Uncoated finish appropriate for dry interior mechanical environments
• Flat head profile seats flush against belting or wooden substrates

Compatibility

Designed as a standard-profile elevator bolt for use in conveyor belting, grain elevator, and agricultural equipment assemblies that specify a 1/4-20 UNC thread and approximately 1 inch overall length fastener with a broad flat head.

Installation Notes

Installation is performed by maintenance technicians and equipment assemblers using standard hand tools. Always de-energize and lock out conveyor or elevator equipment before replacing or installing fasteners per applicable OSHA lockout/tagout procedures. Pair with a matching 1/4-20 UNC nut and appropriate washer as required by the equipment manufacturer. Do not substitute a lower-grade or smaller-head fastener where the original specification calls for an elevator bolt head profile.