Value Collection BNT38 Butt Splice Terminal 2 Awg

Product Description

The VALUE COLLECTION BNT38 is a non-insulated, crimp-on butt splice terminal designed for joining two copper conductors in a single inline connection. Rated for 2 AWG wire, it measures 1.26 inches in overall length and 0.52 inches in overall diameter, making it a compact splice solution for medium-gauge wiring applications. The copper contact material provides reliable conductivity, and the terminal carries both UL Listed and cUL Listed certifications along with RoHS compliance. Electricians and low-voltage technicians use this type of terminal where a clean, permanent butt splice is required without added insulation bulk.

This terminal is suited for residential and commercial electrical work, panel wiring, motor leads, and service entrance connections where 2 AWG conductors need to be spliced inline. Its non-insulated construction is typical in applications where the installer will apply heat-shrink tubing or other protective sleeving after crimping, or where the splice lands inside an enclosure with its own protection. Sold in minimum order quantities of 25 units per order.

Key Features

• Crimp-on connection type for a fast, secure, tool-based termination
• Non-insulated barrel accepts 2 AWG wire on both entry points
• Copper contact material for consistent conductivity
• Compact profile: 1.26 inches overall length, 0.52 inches overall diameter
• UL Listed, cUL Listed, and RoHS Compliant
• Two-wire entry design for true inline butt splice configuration

Compatibility

Designed for use with 2 AWG copper conductors (38.00 sq mm cross-section). Suitable as an inline butt splice terminal in standard electrical wiring assemblies requiring a non-insulated crimp connection at that gauge.

Installation Notes

Installation is performed by licensed electricians using a ratcheting or calibrated crimp tool rated for the terminal size and wire gauge. De-energize and lock out the circuit before making any splice. Ensure conductor ends are clean, stripped to the correct length, and fully seated in the barrel before crimping. Because this terminal is non-insulated, apply appropriate sleeving, tape, or heat-shrink protection after crimping to meet NEC insulation requirements for the installation environment.