Value Collection BN2 Butt Splice Terminal 1.5-2.5 Sq Mm

Product Description

The VALUE COLLECTION BN2 is a non-insulated, crimp-on butt splice terminal designed to join two copper conductors in a single inline connection. Manufactured from copper, it accommodates wire sizes from 1.5 to 2.5 square millimeters and measures 0.591 inches in overall length with a 0.154-inch overall diameter. The two-entry barrel accepts one wire from each end, and a standard crimping tool compresses the barrel to form a gas-tight mechanical and electrical bond. Electricians and low-voltage technicians use this terminal wherever a clean, compact inline splice is required in control wiring, panel wiring, and instrumentation runs.

The BN2 suits residential and light commercial electrical installations, control panel assemblies, HVAC low-voltage wiring, and general instrumentation work. Its non-insulated design is typical in applications where terminals are housed inside an insulated enclosure, covered with heat-shrink tubing post-crimp, or otherwise protected by the surrounding assembly. The compact barrel profile fits tight wire-management channels and terminal-block cavities where bulkier insulated splices would not seat properly.

Key Features

• Crimp-on, non-insulated barrel accepts wire from both ends for an inline butt splice
• Compatible with 1.5 to 2.5 square millimeter copper conductors
• Copper contact material provides good conductivity and corrosion resistance in protected environments
• Compact overall length of 0.591 inches and 0.154-inch diameter fits tight routing spaces
• cUL Listed, UL Listed, and RoHS Compliant for use in code-governed installations
• Minimum order quantity of 50 pieces supports service-truck stocking and panel shop use

Compatibility

Designed as an OEM-style crimp splice for copper conductors ranging from 1.5 to 2.5 square millimeters; suitable for use in any wiring system or enclosure where a non-insulated inline butt splice is appropriate for the wire gauge and environment.

Installation Notes

Installation is performed by a qualified electrician or instrumentation technician following applicable NEC requirements. De-energize the circuit completely before making any splice. Strip each conductor to the depth recommended for the barrel length, insert one wire into each end of the terminal, and apply a calibrated ratcheting crimp tool sized for the wire gauge to compress the barrel. Because this terminal is non-insulated, cover the completed splice with appropriately rated heat-shrink tubing or install it inside an insulated enclosure to meet code requirements for conductor protection.