Value Collection BDNA-32667 Wire Rope Clip 3/8 in

Product Description

The VALUE COLLECTION BDNA-32667 is a malleable iron wire rope clip designed to secure wire rope ends and form fixed loops in rigging and lifting applications. The clip features an electro-galvanized finish that provides corrosion resistance in general industrial and outdoor environments. Built to accept 3/8 inch rope diameter, it delivers a reliable mechanical connection when installed correctly. Malleable iron construction offers the ductility needed to withstand load-induced stresses without sudden fracture. This clip is a staple hardware item used by riggers, ironworkers, and maintenance professionals across a wide range of facilities and job sites.

This wire rope clip is suited for use in industrial rigging, construction hoisting, tie-down applications, and general wire rope termination work where a mechanical end fitting is required. It is appropriate for both light and moderate-duty configurations where 3/8 inch wire rope is the specified line size. The electro-galvanized finish makes it a practical choice for sheltered outdoor or light-moisture environments. Always apply the correct number of clips per rope diameter as specified by applicable rigging standards and manufacturer guidelines.

Key Features

• Accepts 3/8 inch wire rope diameter for a secure mechanical termination
• Malleable iron construction provides ductility and resistance to impact loading
• Electro-galvanized finish offers corrosion resistance in general-duty environments
• Standard clip design compatible with common rigging and wire rope termination practices
• Compact form factor suitable for use in confined rigging points

Compatibility

Designed as a standard replacement or general-use wire rope clip for 3/8 inch diameter wire rope in rigging, lifting, and tie-down assemblies.

Installation Notes

Wire rope clips should be installed by qualified riggers or maintenance professionals familiar with applicable rigging standards such as ASME B30.26. Always de-tension and secure the load before servicing or replacing rigging hardware. The U-bolt saddle must be placed on the dead end of the rope, not the live load-bearing end. Install the minimum number of clips required by the rope diameter and applicable load rating standards, and inspect torque and seating after initial loading.