Value Collection BDNA-24113 Worm Gear Clamp Sae 12

Product Description

The VALUE COLLECTION BDNA-24113 is a worm drive hose clamp rated SAE Size 12, designed to secure hoses and fittings in plumbing, HVAC, and general mechanical applications. The clamp features a stainless steel band that resists corrosion in wet and humid environments. It accommodates a clamping range of 11/16 inches to 1-1/4 inches in diameter, making it suitable for small-diameter hose connections. The band is 1/2 inch wide, providing a reliable sealing surface without deforming soft hose materials. This clamp is installed by plumbers, HVAC technicians, and mechanical contractors as part of routine hose termination and replacement work.

The BDNA-24113 is used across residential and light commercial applications wherever a small-diameter worm gear clamp is required. Typical installations include radiator hoses, coolant lines, low-pressure water supply connections, drain lines, and duct connections. The SAE 12 designation identifies it within a standardized sizing system, simplifying procurement and replacement on job sites that specify clamps by SAE size. This clamp ships individually but carries a minimum order quantity of 10 units, making it practical for stocking in service vans or supply rooms.

Key Features

• Worm drive mechanism allows precise tightening with a standard slotted or hex-head screwdriver
• Stainless steel band resists rust and corrosion in wet and outdoor environments
• Clamping range of 11/16 inches to 1-1/4 inches covers common small-diameter hose sizes
• 1/2 inch band width distributes clamping load evenly to reduce hose damage
• SAE Size 12 designation for straightforward identification and cross-referencing

Compatibility

Designed as a standard worm gear clamp for small-diameter hose and tubing connections in residential and light commercial plumbing, HVAC, and mechanical systems where an SAE 12 clamp with an 11/16 to 1-1/4 inch clamping range is specified.

Installation Notes

Installation is performed by licensed plumbers, HVAC technicians, or qualified mechanical contractors. Ensure the hose or tubing is fully seated on the fitting before positioning and tightening the clamp. Tighten the worm screw gradually and evenly to avoid over-compression or splitting of soft hose materials. Shut off and depressurize any fluid or air line before removing or replacing an existing clamp.