Value Collection BDNA-15852 Wrot Copper 90 Elbow 1 in

Product Description

The VALUE COLLECTION BDNA-15852 is a wrot copper 90-degree elbow fitting designed for sweat-connect copper piping systems. It accepts 1-inch copper pipe on both ends using a copper-to-copper (C x C) end connection, making it suitable for directional changes in pressurized water lines. Wrot copper construction provides consistent wall thickness and reliable joint integrity when soldered. This fitting is installed by licensed plumbers and pipefitters working on residential and light commercial plumbing, hydronic heating, and mechanical systems where copper tubing is specified.

This 90-degree elbow is used wherever a piping run must change direction by 90 degrees in copper distribution systems. Typical applications include domestic hot and cold water supply lines, radiant heating loops, and in-wall or under-slab copper rough-in work. The C x C end connection requires standard soldering (sweat) technique with appropriate flux and solder per applicable plumbing code. Both ends measure 1-1/8 inches outside diameter, consistent with standard 1-inch copper tube sizing.

Key Features

• Wrot copper construction for uniform wall thickness and strong soldered joints
• 90-degree elbow geometry for right-angle direction changes in piping runs
• C x C end connections on both ends accept standard 1-inch copper tubing
• 1-1/8 inch outside diameter on each end matches nominal 1-inch copper tube OD
• Suitable for pressurized domestic water, hydronic, and mechanical piping systems

Compatibility

Designed as an OEM-style replacement and standard-use fitting compatible with nominal 1-inch copper tubing in residential and commercial plumbing systems using sweat (solder) connections.

Installation Notes

Installation should be performed by a licensed plumber in accordance with the applicable International Plumbing Code (IPC) or local plumbing code requirements. Shut off and depressurize the water supply and allow all lines to drain fully before cutting into an existing system. Clean and flux all mating surfaces before soldering; follow local code for approved solder and flux types, particularly on potable water lines. Do not apply heat to the fitting while the line is pressurized or contains residual water.