Value Collection BDNA-15851 Wrot Copper 90 Elbow 3/4 C X C

Product Description

The VALUE COLLECTION BDNA-15851 is a wrot copper 90-degree elbow fitting designed for sweat-connect copper piping systems. It joins two copper pipe runs at a right angle using a copper-to-copper (C x C) end connection, making it a standard component in residential and light commercial plumbing and HVAC refrigerant or hydronic piping assemblies. The fitting is manufactured from wrot copper, which is wrought and worked copper stock known for consistent wall thickness and reliable pressure performance. Both ends accept 3/4-inch nominal copper tubing, with an outside diameter of 7/8 inch at each socket. Licensed plumbers and HVAC technicians install this fitting using standard soldering or brazing procedures.

This elbow is suited for potable water distribution, drain-waste-vent transitions where copper is specified, hydronic heating loops, and refrigerant piping where applicable code allows sweat fittings. It is sold individually per package, with a minimum order quantity of 2 units. The compact form factor fits standard 3/4-inch copper tube runs where a clean 90-degree direction change is required without adapters or transitions.

Key Features

• Wrot copper construction for consistent wall thickness and strong sweat joints
• 90-degree elbow geometry for right-angle direction changes in copper piping runs
• C x C end connection — accepts standard 3/4-inch copper tube on both ends
• 7/8-inch outside diameter socket on each end matches nominal 3/4-inch copper tubing
• Lightweight single-unit packaging suitable for service truck stock

Compatibility

Designed as an OEM-style replacement and general-use fitting compatible with standard 3/4-inch nominal copper tubing in sweat-connect plumbing and HVAC piping systems.

Installation Notes

Installation is performed by a licensed plumber or HVAC technician using standard soldering or brazing equipment in accordance with applicable IPC or IFGC requirements. Shut off and depressurize the water or refrigerant system and allow all pipe surfaces to cool completely before cutting and fitting. Clean all tube ends and fitting sockets with emery cloth and apply appropriate flux before soldering. Do not apply heat to a fitting while fluid or pressure is present in the line.