Value Collection BDNA-15822 Copper 90 Elbow 1 Inch C X C

Product Description

The VALUE COLLECTION BDNA-15822 is a wrot copper 90-degree elbow fitting designed for sweat-connect copper piping systems. It accepts 1-inch nominal pipe on both ends using a copper-to-copper (C x C) end connection, with an outside diameter of 1-1/8 inches on each end. Wrot copper construction provides consistent wall thickness and high-pressure integrity, making it a reliable choice for hydronic heating, domestic water supply, and plumbing distribution systems. Licensed plumbers and HVAC technicians install this fitting using standard torch-and-solder technique to create a permanent, leak-resistant joint.

This elbow is suited for residential and light commercial plumbing applications where a 90-degree directional change is required in a 1-inch copper water or heating line. Typical install scenarios include supply and return lines for boilers, domestic hot and cold water distribution, and radiant heating manifold connections. The C x C configuration requires both pipe ends to be cleaned, fluxed, and soldered per applicable plumbing code requirements.

Key Features

• Wrot copper construction for uniform wall thickness and pressure reliability
• 90-degree elbow geometry for right-angle directional changes in copper piping runs
• C x C (sweat) end connections on both ends for standard solder-joint assembly
• 1-1/8-inch outside diameter on each end matches 1-inch nominal copper pipe
• Compact form factor suitable for tight chase or mechanical room installations

Compatibility

Designed as an OEM-style replacement and new-installation fitting for 1-inch nominal copper pipe systems using standard sweat-solder (C x C) connections in residential and light commercial plumbing and hydronic applications.

Installation Notes

Installation should be performed by a licensed plumber in accordance with the International Plumbing Code (IPC) and applicable local codes. Shut off and drain the water supply before cutting into any existing line. Clean pipe ends and fitting cups thoroughly, apply appropriate flux, and solder using lead-free solder where required by code. Do not apply heat to a fitting that is still wet or under pressure.