Value Collection BDNA-15648 Copper Pipe Adapter 1/2 in

Product Description

The VALUE COLLECTION BDNA-15648 is a wrot copper pipe adapter designed to transition between a copper sweat (C) connection and a female threaded (F) connection in residential and light commercial plumbing systems. At 1/2 inch by 1/2 inch, this adapter is built from wrot copper, which offers superior pressure ratings and reliability compared to cast fittings. It is sized for standard 1/2-inch copper tubing with an outside diameter of 5/8 inches on the sweat end and a 1/2-inch female threaded port. Plumbers and pipe fitters use adapters like this to connect copper tubing runs to threaded valves, fixtures, or equipment inlets.

This adapter is suited for potable water supply lines, hydronic heating distribution piping, and general plumbing retrofit work where a sweat-to-female-thread transition is required. The C x F configuration allows the installer to solder the fitting directly onto cleaned and fluxed copper tubing on one end while threading a compatible male-threaded component into the opposite end. It is appropriate for both new construction and service replacement applications in residential and light commercial settings.

Key Features

• Wrot copper construction for high-pressure integrity and long service life
• C x F end configuration: sweat inlet to female threaded outlet
• 1/2 inch by 1/2 inch fitting size fits standard 1/2-inch copper tubing
• 5/8-inch outside diameter on the copper sweat end matches standard 1/2-inch tube OD
• Compact form factor suitable for tight installation spaces

Compatibility

Designed as an OEM-style replacement or new-installation fitting for standard 1/2-inch copper plumbing systems using sweat-to-female-thread connections.

Installation Notes

Installation should be performed by a licensed plumber in accordance with applicable local plumbing codes and the International Plumbing Code (IPC). Shut off the water supply and relieve system pressure before beginning work. The copper sweat end requires proper tube preparation, including cutting, deburring, cleaning, and flux application before soldering. Do not apply thread sealant or PTFE tape to the female threaded end until the soldered joint has fully cooled.