Value Collection BDKP84186 Steel Preformed Clamp 1.5 in Id

Product Description

The VALUE COLLECTION BDKP84186 is a preformed steel clamp designed to secure tubing, hose, or conduit runs in mechanical and plumbing installations. With a 1.5-inch inner diameter and a 5/8-inch-wide band, this clamp provides consistent grip across the pipe or tube surface without distorting the material. The preformed design holds its shape during installation, making single-technician mounting straightforward. Each package contains 4 clamps, making it practical for small repairs or multi-point securing tasks on the same run. Fabricated from steel, these clamps suit applications where a rigid, durable hold is required.

These clamps are suited for use in HVAC, plumbing, and general mechanical service environments where lines must be anchored to framing, strut, or structural supports. The 1.5-inch ID accommodates standard pipe and tubing sizes commonly found in residential and light commercial systems. Installers use these clamps when securing refrigerant lines, water supply lines, conduit, or similar round-profile runs in both new construction and retrofit work. The pack quantity of 4 supports multi-point securing along a single line segment.

Key Features

• 1.5-inch inner diameter fits standard pipe and tubing of that outside dimension
• 5/8-inch-wide band distributes clamping load evenly around the pipe surface
• Preformed steel construction holds shape during handling and installation
• Sold in packs of 4 for efficient use on multi-clamp runs
• Steel material provides rigid, durable support in mechanical service environments

Compatibility

Designed as a general-purpose preformed clamp for securing round pipe, tubing, or conduit with a 1.5-inch outer diameter in HVAC, plumbing, and mechanical installations.

Installation Notes

Preformed pipe clamps are typically installed by licensed plumbers, HVAC technicians, or mechanical contractors during pipe-run securing work. Shut off fluid flow and depressurize any line being worked on before mounting clamps. Fasten clamps to structural supports using appropriate fasteners for the substrate, following applicable IPC or IFGC guidelines for pipe support spacing. Do not overtighten fasteners in a way that deforms the clamp or the pipe wall.