Value Collection BDC87695 Rubber Grommet 1-5/16in Od

Product Description

The VALUE COLLECTION BDC87695 is a rubber grommet designed to protect wiring, tubing, and cable runs where they pass through metal panels, chassis walls, and enclosures. The grommet seats into a punched or drilled opening and cushions the edge to prevent abrasion and chafing of insulation or jacketing. With an outside diameter of 1-5/16 inches, a slot diameter of 1 inch, a slot width of 1/4 inch, and a thickness of 9/16 inch, it fits a standard panel cutout while providing a secure, snug seal around the routed material. The inside diameter is 11/16 inch. The all-rubber construction stays flexible across typical service temperature ranges encountered in HVAC, electrical, and plumbing panel applications.

This grommet is used wherever conductors, control wiring, refrigerant tubing, or small-diameter pipe or conduit must pass cleanly through a sheet metal panel, junction box knockout, or equipment cabinet wall. It is a common component in residential and light commercial HVAC equipment, electrical enclosures, and plumbing rough-in assemblies. Electricians, HVAC technicians, and plumbers install this type of grommet during equipment assembly or service to maintain wire protection and meet workmanship standards required by applicable codes. Sold in a package quantity of 25.

Key Features

• Rubber construction provides flexible, durable edge protection for cables and tubing
• 1-5/16 inch outside diameter fits standard panel cutouts
• 1 inch slot diameter and 1/4 inch slot width accommodate a range of cable and tubing diameters
• 11/16 inch inside diameter opening for routed material
• 9/16 inch thickness provides panel grip and seating depth
• Packaged in quantities of 25 for service-truck and job-site stocking

Compatibility

Designed as a standard rubber panel grommet suitable for use in HVAC equipment, electrical enclosures, and plumbing panel assemblies wherever a 1-5/16 inch OD grommet seat is required.

Installation Notes

Installation requires no specialized tools — the grommet is pressed by hand into a clean panel opening sized to accept the outside diameter. Ensure the panel edge is free of burrs before seating to avoid tearing the rubber. Power down or de-energize any enclosure before routing conductors through the grommet. Follow applicable NEC or equipment manufacturer guidelines for conductor fill and protection at panel penetrations.